4.Secure the cable to the vehicle structure at approximately one foot intervals, taking care not to over tighten, pinch con- ductors, or penetrate the insulation.
5.Connect the watertight connector end of the power cable to the Thor VM2 Quick Mount Smart Dock power connector by aligning the connector pins to the power connector; push down on the watertight connector and twist it to fasten securely.
6.Secure the power cable to the Thor VM2 using strain relief cable clamps, and place the Thor VM2 in the dock.
7.If using the Screen Blanking feature, install the screen blanking box or switch. (Refer to the installation instructions that came with the Screen Blanking box, or to the Thor VM2 User’s Guide, available at www.honeywellaidc.com for fur- ther information about the Screen Blanking box.)
8.Press the power switch on the back of the Thor VM2 dock.
9.Press the power button on the front of the Thor VM2.
Thor VX8/VX9 Adapter Cable
This adapter cable is available to attach the Thor VM2 to a vehicle previously equipped with a VX8/VX9 DC power cable. This cable has bare wires for ground and ignition sense connection plus a D9 cable that connects to a COM port on the Thor VM2 dock to provide a screen blanking signal.
1.The Thor VM2 must not be mounted in the Quick Mount Smart Dock. The power switch on the dock must be turned Off. The power cable must be UNPLUGGED from the dock.
2.Connect the cable to the Thor VM2 power cable by aligning the connector pins to the power connector; push down on the watertight connector and twist it to fasten securely.