Lubrication

The motor is equipped with bearings, which have been lubricated for the life

of the motor. The addition of lubricant could cause damage.

Therefore, do

not add lubricant to either motor bearing.

The agitator is equipped with two ball bearings that should be lubricated

periodically by a Hoover Factory Service Center or an Authorized Warranty

Service Dealer.

If you have a problem

This appliance was inspected thoroughly and was in good operating

condition when it was shipped from the factory. If a minor problem occurs,

it usually can be solved quite easily when the cause is found. Therefore,

this check list is provided to assist you.

Problem Possible cause Possible solution
A
Cleaner
won?
run
1. Not firmly plugged in.
2. No voltage in wail plug.
3. Blown fuse/tripped breaker.
1. Plug unit in firmly.
2. Check fuse or breaker.
3. Replace fuse/reset
breaker.
8.
Cleaner
suction
low
1. Bag full.
2 Obstruction in hose,
wands, or nozzle connector.
3. Secondary
filter
dirty.
4 Bag not opening.
5. Suction regulator control
improperly set.
6.
Hose not property con-
netted to cleaner.
1. Change paper bag.
2. Remove foreign object.
3. Clean filter.
4.
kg;
bag
by
Winci
.
5. Adjust suction regulator.
6. Reconnect hose.
C. Agitator
won’t run
1. Hose power cord not
firmly plugged in.
2 Broken or worn
betL
3. Nozzle sealed to carpet
1. Plug
firmiy
into receptacle
on cleaner base and
underneath hand grip.
2. Replace bett
3. Open suction regulator.
D. Nozzle
won’t
pick up
1. Low cleaner suction.
2 Obstruction in nozzle
connector.
3. Agitator not running.
4. Agitator brushes worn.
1. SeeitemB.
2. Remove foreign object.
3. see item c.
4. Replace brushes.

17