Hoover HFI647X, HBI647MR, HBI637 manual Installation, Built-In, Electrical Connection, L1 L2

INSTALLATION

Installing a domestic appliance can be a complicated operation which if not carried out correctly, can seriously affect consumer safety. It is for this reason that the task should be undertaken by a professionally qualified person who will carry it out in accordance with the technical regulations in force. In the event that this advice is ignored and the installation is carried out by an unqualified person, the manufacturer declines all responsibility for any technical failure of the product whether or not it results in damage to goods or injury to individuals.

BUILT-IN

The furniture in which your hob will be installed and all adjacent furniture, should be made from materials that can withstand high temperatures. In addition, all decorative laminates should be fixed with heat-resistant glue.

Installation:

• A watertight seal is supplied with the hob.

Before fitting:

-turn the hob upside down, with the glass surface facing downwards.

Make sure the glass is protected.

-fit the seal round the hob.

-make sure that it is correctly fitted to avoid any leakage into the supporting cabinet.

•It it important to fit the hob on a level supporting surface.

•Deformations caused by incorrect fitting can alter the specifications

of the worktop and the performance of the hob.

•Leave a gap of at least 5 cm between the appliance and any neighbouring vertical surfaces.

•It is absolutely essential that the recess conforms with the dimensions indicated.

•Cut a hole in the worktop of the dimension shown in the diagram below.A minimum of 50 mm space should be left around the hole.

•The worktop should be at least 30 mm thick and made of heat-resistant material.As shown in the Figure(1)

ELECTRICAL CONNECTION

"The installation must conform to the standard directives." The manufacturer declines all responsibility for any damage that may be caused by unsuitable or unreasonable use.

Warning :

•Always check before any electrical operation, the supply tension shown on the electricity meter, the adjustment of the circuit- breaker, the continuity of the connection to earth to the installation and that the fuse is suitable.

•The electrical connection to the installation should be made via a socket with a plug with earth, or via an omnipole cut-out switch with an opening gap of at least 3 mm.

If the appliance has a socket outlet, it must be installed so that the socket outlet is accessible.

•The yellow/green wire of the power supply cable must be connected to the earth of both power supply and appliance terminals.

•The manufacturer cannot be held responsible for any accidents resulting from the use of an appliance which is not connected

to earth, or with a faulty earth connection continuity.

•Any queries regarding the power supply cord should be referred to After Sales Service or a qualified technician.

•If the cable is damaged or to be replaced, the operation must be carried out the by sale agent with dedicated tools to avoid any accident.

Connection to power supply

The socket shall be connected in compliance with the relevant standard, to a single-pole circuit breaker. The method of connection is shown in Figure(3):

Seal	L1 L2	N1	N2
			Grey

•You can not build the hob in above an oven with no fan, a dishwasher, fridge, freezer or washing machine.

•It is essential that the induction hob is well ventilated and that the air intake and exit are not blocked.

Make sure the hob is correctly installed as shown in Figure(2)

JIKI D HJ	A`i \o`k
	JIKI D JJ

JIKI B HJ

A`i `ekXb\

The cable must not be bent or compressed.

NB: For safety, the gap between the hob and any cupboard above it should be at least 760mm.

2 GB