40003324.qxd 28/06/2006 12:59 Page 7

Installation

Electrical requirements

Tumble dryers are supplied to operate at a voltage of

230-240V, 50 Hz single phase. Check that the supply circuit is rated to at least 13A.

This appliance is fitted with a moulded-on non-rewireable plug which is already equipped with a BS 1362 ASTA approved 13A fuse. Any replacement must be the same rating and specification. If the fuse cover is lost, do not use the plug until it is replaced.

Electricity can be extremely dangerous. This appliance must be earthed.

The socket outlet and the plug on the appliance must be of the same type.

Do not use multiple adapters and/or extension leads.

The plug should be accessible for disconnection after the appliance has been installed.

The wires in the mains lead are coloured in accordance with the following codes:

BlueNEUTRAL

BrownLIVE

Green and Yellow EARTH

CE Appliance complies with European Directive 89/336/EEC, 73/23/EEC and subsequent amendments.

Water supply

This machine must be connected to a cold water supply.

The cold water pressure should be between 0.5 and 8 bar (0.05-0.8 Mpa).

Do not connect the machine to a hot water supply or single outlet instantaneous water heater.

The water supply tap should be accessible when the machine is installed.

Before connecting the fill hose, check that water is running from the water supply tap to be used.

Do not plug the

machine in and switch it on at the mains until the installation is completed.

You may be charged for

a service call if a

problem with your

machine is caused by incorrect installation.

If the mains cord on

this appliance is

damaged, it must be replaced by a special cord which is ONLY obtainable from the Hoover spares service. It must be installed by a

competent person.

Call

01204 556111

7

Page 7
Image 7
Hoover HHD780 X manual Installation, Electrical requirements, Water supply