The assembled cleaner will look like this drawing.
Assemble handle
Attach upper handle
Remove clean solution tank (upper tank) from deep cleaner.
With cord hook (A) to back of deep cleaner, push upper handle down onto lower han- dle. Push bolts into holes on front of han- dle. If bolts will not go through hole easi- ioh$dle is not pushed completely
-
x
Place nuts in recessed areas on back of handle. Hold each nut in place while tightening each bolt securely with a Phillips screw driver.
Only two nuts are needed on this model. The extra nut is not required but has been provided for your convenience.
When handle sections are completely together, squeeze trigger (B) on upper handle to snap tripqer rod In place.
Replace clean solution tank (upper tank) by positioning bottom first. Press on tank handle to snap top of tank into place.
Press cord into cord clip on back of | Attach hose clip | Pivot clip and push other tab into hole |
handle. Pull cord tight. | Push tab on side of clip into hole on | at back of handle to lock into place. |
|
| |
| side of handle. |
|
4
