![](/images/new-backgrounds/1059865/5986521x1.webp)
| |
C | E |
6.With curved ends down, slide end plates (C) of brush roll into slots (E) on tool.
B
A
7. Replace belt guard (B) making sure | 8. To replace bottom plate (A), insert the | |
four tabs on edge of bottom plate into | ||
not to pinch brush bristles in guard. Turn | slots on front of tool. | |
agitator, to make sure it rotates freely. | Pivot bottom plate down and snap | |
Replace and tighten screws. | ||
closed. | ||
|
Powered hand tool
Belt replacement
Inspect the belt
The powered hand tool belt is designed to last a long time and is not normally replaced. However, if the belt is crack- ed, gouged or broken, it should be replaced.
The belt can be seen through the top of the nozzle or by removing the bottom plate and belt guard (Figs.
Replace belt
When replacing belt, ask for HOOVER
part No. 38528037.
1.Remove bottom plate, belt guard and brush roll as described in Figs.
F | |
| E |
2.Grasp turbine (E) and pull firmly to remove.
3.Remove belt from turbine pulley (F). Replace with new belt.
H |
G |
4.With flat sides of turbine retainers (G) pointing down, slide retainers into grooves (H) in tool housing and snap into place.
5.Replace brush roll, belt guard, and bottom plate as described in Figs.
Continued ➜ | 11 |
|