HOW TO ASSEMBLE YOUR
NEW HOOVER CLEANER
ASSEMBLE HANDLE PIECES
Remove cardboard from end of handle pieces.
Slide the two handle pieces together. Check to see that cord clips are on the same side of the handle. Insert bolt through small holes and secure with nut. Tighten nut with screwdriver.
If the nut and bolt are not
assembled as shown in the
illustration, the holes in the handle pieces are not lined up correctly.
ATTACH HANDLE TO CLEANER
Unscrew nut and remove bolt and plate from handle socket. Place handle so that the holes in the bottom of the handle are directly
in line with the electrical prongs and make sure the handle is
positioned so that the switch is to rear of cleaner.
Push down until handle is
securely in place. Insert bolt
through small holes of handle
pieces and secure with nut.
Tighten nut with screwdriver.
If boll appears' too short, the
plate is on backwards or upside
down. Make sure that the con-
tour of the plate fits around the handle as in illustration.
OPERATE THIS CLEANER ONLY AT VOLTAGE SPECIFIED ON DATA PLATE ON BOTTOM OF CLEANER.
(c The Hoover Company 197
