Secondary and final filters
|
G |
Cleaning secondary filter
Disconnect cleaner from electrical outlet.
The secondary filter (G), located under- neath the retainer in the bottom of clean- er cavity, protects the motor from dirt particles.
If filter becomes dirty, remove dirt cup (Fig.
Hand wash filter in cold water with mild detergent, then air dry.
Reposition dry filter, retainer and screw. Replace dirt cup.
Should you want to replace this filter, ask for HOOVER part No. 38765019.
|
Cleaning final filter
The final filter assists in returning clean air to the room.
To remove this filter when it becomes dirty, remove dirt cup and pull down top of filter.
|
H |
Removing and replacing filter
Lift out filter (H) and hand wash it in cold water with mild detergent.
Let filter air dry and reposition it on the side of cleaner.
Reposition dirt cup.
Should you want to replace this filter, ask for HOOVER part No. 43613026.
Do not operate cleaner without any of the filters in place.
Check agitator shield
Because your cleaner picks up so well, we strongly recommend you check for debris accumulation under the agitator shield each time you clean the filters.
Removing debris under the shield will help maintain your cleaner’s excellent pick up and suction. Remove debris as follows:
1.Disconnect cleaner from electrical outlet.
2.Check for dirt accumulation by remov- ing bottom plate (Fig.
3.Remove any debris and replace shield, agitator and bottom plate (Figs.
Headlight replacement
What to buy
This cleaner uses a 12 volt, wedge base type 912 bulb, HOOVER part No. 27313101.
3-15
Remove lens - Disconnect clean- er from electrical outlet.
Using a screwdriver, remove the two screws as shown and lift off lens.
3-16
Install bulb - Pull old bulb straight out of socket. Push new bulb straight into socket until locked in place
Excessive force is not required.
10
