Hoover U5361950 Transporting cleaner, Carrying handle, Carpet height adjustment, Handle position

2-4

Transporting cleaner

Put handle in upright position. Tilt cleaner back on rear wheels. Push forward.

2-5

Carrying handle

Use the carrying handle to lift the cleaner.

2-6
B	A

Carpet height adjustment

The cleaning of carpet and rugs takes place at the nozzle (A).

When it is necessary to raise and lower the nozzle for various carpet pile heights, slide the nozzle control knob (B) to the desired setting.

2-7

C

D

Handle position

For ease in sliding knob, place handle in the upright position (C).

The nozzle will not move into the adjusted position until the cleaner handle is lowered to the operating position (D).

2-8

High	Hard
	Floor

Settings

For maximum cleaning performance,

the following carpet height settings are recommended.

•Lowest setting:for all types of carpet and hard floors.

Note: If the cleaner is difficult to push, slide knob to the next higher setting.

•Higher settings:for very deep pile carpet where easier pushing effort is desired, while maintaining good cleaning performance.

2-9

Cleaning lightweight flexible rugs

Stand on one end of rug and move cleaner toward other end or edge. Before reaching edge, push down on handle. This will lift up the nozzle (front of cleaner) as shown and will prevent rug from clinging to cleaner. Continue to lift up nozzle so that when you have reached the edge, it is completely off the rug. Move cleaner back to start again, lower nozzle, and use only for- ward strokes.

6