Lubrication
The motor is equipped with bearings that contain sufficient lubrication for the life of the motor. The addition of lubricant could cause damage. Therefore, do not add lubricant to motor bearings.
The agitator brush roll is equipped with two ball bearings that should be lubricated periodically by a Hoover Sales and Service Center or an Authorized Hoover Warranty Service Dealer.
Thermal Protector
An internal thermal protector has been designed into your cleaner to protect it from overheating.
When the thermal protector activates, the cleaner will stop running. If this happens, proceed as follows:
1.Turn the cleaner OFF and disconnect it from the electrical outlet.
2.Check secondary and final filters for dirt accumulation.
3.Refer to “Clearing blockages” section.
4.When cleaner is unplugged and the motor cools for 30 minutes, the thermal protector automatically resets and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner may need servicing (see “Service” section).
Service
To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Sales and Service Center or Authorized Hoover Warranty Service Dealer (Depot) by:
•checking the Yellow Pages under “Vacuum Cleaners - Household”
•checking the Service section of Hoover
•calling
Do not send your cleaner to Hoover in Glenwillow, Ohio for service, this will only result in delay.
If further assistance is needed, contact the Hoover Consumer Response Center, Phone:
In Canada: Carson Building; 100 Carson St.; Etobicoke, ON; M8W3R9;
Always identify your cleaner by the complete model number when requesting information or ordering parts. (The model number appears on the back of the cleaner.)
14
