Secondary and final filters
Replacing bag door
Reposition bag door by placing tab on bottom of door into opening (C).
Press top of door to snap securely shut.
Cleaning secondary filter
Disconnect cleaner from electrical outlet.
The secondary filter (A), located behind the grill in the bottom of bag compartment, protects the motor from dirt particles.
If filter becomes dirty, pull off grill and lift out filter,
Hand wash filter in cold water with mild detergent, then air dry.
Reposition dry filter and grill.
Should you want to replace this filter, ask for HOOVER part No. 38765019.
Replacing final filter
The final filter assists in the filtration process to return clean air to the room.
The pleated filter will become dirty and needs to be replaced about once a year to maintain efficient filtration. The 3 layer filter (some models) can be washed in the same manner as the secondary filter and reused.
To remove final filter, first open the door on the side of the cleaner (Fig.
Grasp filter (B) and pull it straight out.
Reposition new filter by reversing this procedure.
The final filter can be replaced with any of the following filters.
3 layer, washable - HOOVER part No.
40110006
HEPA filter HOOVER part No. 43613022
Do not operate cleaner without both the secondary and final filter in place.
How to reattach filter door
The filter door is designed with a “break- away” feature which allows it to snap free if it is pushed open too far.
To reattach, align hinges (C) of cover with slots on sides of filter area.
Press door back into place.
Check brush roll charm= nels
Because your WindTunnel”cleaner picks up so well, we strongly recommend you
check for debris accumulation in the channels next to the brush roll when you check the filters. Removing this debris will help maintain you cleaner’s excellent pick up and suction. Remove debris as follows:
Disconnect cleaner from electrical outlet.
Check for debris accumulation by removing bottom plate (Fig.
Remove any accumulation.
Reposition bottom plate (Fig.
lii;flight replace-
What to buy
This cleaner uses a 12 volt, wedge base type 912 bulb, Hoover part No. 27313101.
Removing lens
Disconnect cleaner from electrical outlet.
Using a Phillips screwdriver, remove the two screws as shown and lift off lens.