Hoover WindTunnelTM Now that your new, Self-Propelled, vacuum cleaner is, operations, E F G F

STEP I Attach handle		1-3	1 - 4
1-2				D
	A			B
				C

Looking at the back of the cleaner, make sure switch (A) is in the OFF position.

Slide handle into back of cleaner.

Push screws into holes on back of handle.

Using a Phillips screw driver, tighten screws securely.

Remove switch lock (B) above ON- OFF switch (C) on front of handle by pulling it straight out. Dispose of lock.

If switch lock has come off during assembly, make sure switch is in OFF position (down) before plug- ging cord into electrical outlet.

Remove label (D) from self-propel button.

STEP II Attach hose	NOTE: Hose must be connected as shown for all
	operations.
1-5	1-6	1-7

E

F

G

F

Align end of hose with projection (E) over slots (F) in dirt duct on back of handle.

Slide hose into (F) and twist hose to lock it into place.

Position hose over rack and into hose tube (G).

STEP III Position tools

1-8

Place smaller diameter end of wand, into bottom of rack. Snap wand into clip at the top. Repeat with other wand.

1-9	J	Now that your new
		Self-Propelled
		TM
		WindTunnel
	I	vacuum cleaner is
		H

assembled,

it’s ready to use!

Open tool cover.

Insert ends of dusting brush (H), crevice tool (I) and furniture nozzle

(J)into storage areas. Close tool cover.

4