Hoover WindTunnelTM manual Secondary and final filters, Headlight, replacement, Cleaning secondary

3 - 2 3 - 3

C

A

Secondary and final filters

3 - 4

A

B

Removing and installing filter	Replacing bag door
b a g	Reposition bag door by placing tab on
Grasp filter bag collar (A) and pull collar
	bottom of door into opening (C).	Cleaning secondary
from tube (B).	Press top of door to snap securely shut.
		filter
Note: Do not clean out old filter bag and
		Disconnect cleaner from electrical
reuse. Discard used filter bag.
Hold new filter bag as shown. Align open-		outlet.
		The secondary filter (A), located
ing in filter bag with (B).
Push (A) firmly onto (B).		behind the grill in the bottom of bag
		compartment, protects the motor from
Tuck in filter bag.
		dirt particles.
		If filter becomes dirty, pull off grill and lift
		out filter.
		Hand wash filter in cold water with mild
		detergent, then air dry.
		Reposition dry filter and grill.
		Should you want to replace this filter,
		ask for HOOVER part No. 38765019.
3 - 5	3 - 6	Check for debris accumulation by
		removing bottom plate (Fig. 3-9) and
		looking in the channels (I) next to the
		brush roll (Fig. 3-18).
	C	Remove any accumulation.
		Reposition bottom plate (Fig. 3-13).
B		Headlight
		replacement

Replacing final filter

The final filter assists in the filtration process to return clean air to the room.

This pleated filter will become dirty and needs to be replaced about once a year to maintain efficient filtration. The 3 layer filter (some models) can be washed in the same manner as the secondary filter and reused.

To remove final filter, first open the door on the side of the cleaner (Fig. 3-5).

Grasp filter (B) and pull it straight out.

Reposition new filter by reversing this procedure.

The final filter can be replaced with any of the following filters.

3 layer, washable - HOOVER part No.

40110006

HEPA filter HOOVER part No. 43613022.

Do not operate cleaner without both the secondary and final filter in place.

How to reattach filter door

The filter door is designed with a “break-away“ feature which allows it to snap free if it is pushed open too far.

To reattach, align hinges (C) of cover with slots on sides of filter area.

Press door back into place.

Check brush roll chan- nels

TM

Because your WindTunnel cleaner picks up so well, we strongly recom- mend you check for debris accumula- tion in the channels next to the brush roll when you check the filters. Removing this debris will help maintain you cleaner’s excellent pick up and suc- tion. Remove debris as follows:

Disconnect cleaner from electrical outlet.

What to buy

This cleaner uses a 12 volt, wedge base type 912 bulb, Hoover part N o .

2 7 3 1 3 1 0 1.

3 - 7

Removing lens

Disconnect cleaner from electrical outlet.

Using a Phillips screwdriver, remove the two screws as shown and lift off lens.

Continued 9