A S S E M B LY STEP 1
HARDWARE BAG FOR STEP 1 CONTENTS :
BOLT (A) | ARC |
|
WASHER (C) |
| |
15 mm | 17 mm |
|
Qty: 6 | Qty: 2 |
|
SPRING | angle view | FLAT |
WASHER (B) |
| WASHER (D) |
15 mm |
| 20 mm |
Qty: 6 |
| Qty: 4 |
IMPORTANT PRECAUTIONS INTRODUCTION
2.3E SHOWN |
|
|
|
|
| BOLT (A) |
|
CONSOLE MAST |
| SPRING WASHER (B) |
|
|
|
| |
|
| ARC WASHER (C) |
|
|
| FLAT WASHER (D) |
|
|
| BOLT (A) |
|
TOP CAP | CONSOLE WIRES | SPRING WASHER (B) |
|
|
|
| |
|
| 3.3E and 4.3E ONLY | MAST BOOT |
| MAIN FRAME BRACKET | ||
|
| CONSOLE MAST |
|
| MAIN FRAME |
|
|
|
|
| TOP CAP |
A)Open HARDWARE BAG FOR STEP 1.
B)Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the CONSOLE MAST.
C)(For Models: 3.3E and 4.3E only) Slide the MAST BOOT onto and up the CONSOLE MAST.
D)Slide the TOP CAP onto and up the CONSOLE MAST.
E)Attach the CONSOLE MAST to the MAIN FRAME BRACKET using 2 BOLTS (A), 2 SPRING WASHERS (B), and 2 ARC WASHERS (C) on the front of the console mast. Attach the CONSOLE MAST on the sides using 2 BOLTS (A), 2 SPRING WASHERS (B), and 2 FLAT WASHERS (D) on each side.
F)Slide the TOP CAP (and boot if applicable) down onto the MAIN FRAME.
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES
