Horizon Fitness Essential Assembly Guide for Horizon Treadmills

INTRODUCTION IMPORTANT PRECAUTIONS

ASSEMBLY

A S S E M B LY

IMPORTANT: READ THESE SAFETY INSTRUCTIONS BEFORE USE!

WARNING

During the assembly process of the treadmill there are several areas that special attention must be paid. It is very important to follow the assembly instructions correctly and to make sure all parts are firmly tightened. If the assembly instructions are not followed correctly, the treadmill could have frame parts that are not tightened and will seem loose and may cause irritating noises. There should be no side-to-side play in the console masts or any forward and back play in the console assembly or handlebars. If there is any play in these areas, the treadmill has not been properly assembled. To prevent damage to the treadmill, the

READING RACK / MP3 STORAGE WATER BOTTLE HOLDER

GRIP PULSE HANDRAILS

SUPPORT BAR

HANDLEBARS

ON/OFF SWITCH

CIRCUIT BREAKER

POWER CORD

CONSOLE

TOUCH PAD PANEL

FAN SAFETY KEY PLACEMENT

CONSOLE MAST

MOTOR COVER FOOT LOCK LATCH RUNNING BELT / RUNNING DECK

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE

YOU BEGIN

TREADMILL

OPERATION

CONDITIONING TROUBLESHOOTING LIMITED

GUIDELINES & MAINTENANCE WARRANTY

6

assembly instructions must be reviewed and corrective actions should be taken.

UNPACKING

Place the treadmill carton on a level flat surface. It is recommended that you place a protective covering on your floor. Take CAUTION when handling and transporting this unit. Never open box when it is on its side. Once the banding straps have been removed, do not lift or transport this unit unless it is fully assembled and in the upright folded position, with the lock latch secure. Unpack the unit where it will be used. The enclosed treadmill is equipped with high-pressure shocks and may spring open if mishandled. Never grab hold of any portion of the incline frame and attempt to lift or move the treadmill. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!

Before proceeding, find your treadmill’s serial number and model name located to the left of the on/off power switch and power cord and enter it in the space provided below.

enter your serial number and model name in the boxes below:

SERIAL NUMBER:

MODEL NAME:

*Refer to the serial number and model name when calling for service.

*Also enter this serial number on your Warranty Card.

	SIDE RAIL
	ROLLER END CAP
TRANSPORT WHEEL
AIR CELL	REAR ROLLER
	ADJUSTMENT BOLTS

TOOLS INCLUDED

4mm L-wrench 17mm Flat Wrench 5 mm T-wrench

6 mm T-wrench

10 mm L-wrench

PARTS INCLUDED

1 Safety Key

1 Console Assembly (located under treadmill deck)

1 Power Cord

5 Hardware Bags

2 Handlebars

2 Console Masts

1 Bottle of Silicone Lubricant

1 Support Bar

If you have questions or if there are any missing parts, contact Customer Tech Support.

Contact information is located on the back panel of this manual.

For a complete exploded diagram, visit us at www.horizonfitness.com

7

BEFORE YOU BEGIN

TREADMILL OPERATION

LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES

CT81_Treadmill_Rev.1.8.indd 6-7 5/29/07 8:51:09 AM