INTRODUCTION IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
CONDITIONING TROUBLESHOOTING LIMITED
GUIDELINES & MAINTENANCE WARRANTY
A S S E M B LY STEP 2 |
|
| CONSOLE MAST |
BOLT (A) | CONSOLE MAST BOOT |
| |
SPRING WASHER (B) | TOP BACK COVER |
| |
FLAT WASHER (C) |
|
TOP FRONT COVER |
|
| CONSOLE WIRES |
MAIN FRAME |
|
A)Open HARDWARE BAG FOR STEP 2.
B)Carefully pull the CONSOLE CABLES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
C)Attach the CONSOLE MAST to the MAIN FRAME using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4 FLAT WASHERS (C).
D)Attach the TOP FRONT COVER, followed by the TOP BACK COVER and snap them together.
E)Slide CONSOLE MAST BOOT down to seal the console mast hole.
HARDWARE BAG FOR STEP 2 CONTENTS :
413*/(8"4)&3 # | ||
NN | NN | NN |
2UZ | 2UZ | 2UZ |
A S S E M B LY STEP 3 |
PEDAL ARM TUBE |
TEFLON WASHERS (F) |
FLAT WASHER (G) |
BOLT (H) |
LINK ARM BRACKET |
SPACER (E) |
LOWER LINK ARM |
PEDAL ARM |
A ) Open HARDWARE BAG FOR STEP 3.
B)Align the bracket on the LEFT LOWER LINK ARM with the tube on the LEFT PEDAL ARM.
C)Slide the SPACER (E) through the LINK ARM BRACKET and the PEDAL ARM so it can’t rotate.
D)Insert 2 TEFLON WASHERS (F) between the PEDAL ARM and the LINK ARM BRACKET.
E)Secure the joint with a FLAT WASHER (G) and BOLT (H).
F)Repeat on the other side.
HARDWARE BAG FOR STEP 3 CONTENTS : |
|
| SPACER (E) |
| 70 mm axis |
SPLIT TEFLON WASHER (F) | Qty: 2 |
| |
30 mm |
|
Qty: 4 |
|
BOLT (H) | FLAT WASHER (G) |
15 mm | 35 mm |
Qty: 2 | Qty: 2 |
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES
LS_645E_Rev.1.7.indd | 6/25/08 10:43:26 AM |
