Horizon Fitness SXS 5.7 manual Open Hardware BAG, Radial ARM Assmbly

INTRODUCTION

IMPORTANT PRECAUTIONS

A S S E M B LY STEP 2

HARDWARE BAG 1 CONTENTS :

BOLT (A)	FLAT WASHER (B)	NYLON NUT (C)
Qty: 4	Qty: 12	Qty: 6
BOLT (D)	SUPPORT PLATE
Qty: 2	Qty: 2

A S S E M B LY STEP 3

HARDWARE BAG 2 CONTENTS :

BOLT (A)	FLAT WASHER (B)	NYLON NUT (C)	SCREW (F)
Qty: 2	Qty: 4	Qty: 2	Qty: 4

SCREW (F)

INTRODUCTION

IMPORTANT PRECAUTIONS

ASSEMBLY

BEFORE

YOU BEGIN

CONDITIONING

GUIDELINES

TROUBLESHOOTING & MAINTENANCE

WARRANTY
LIMITED
	

	UPPER PULLEY ASSEMBLY
	FLAT WASHER (B)
	NYLON NUT (C)
BOLT (D)
FLAT WASHER (B)
LAT BAR
BRACKET ASSEMBLY
		SUPPORT PLATE
FLAT WASHER (B)		FLAT WASHER (B)
		BOLT (A)
NYLON NUT (C)
		LEFT SUPPORT
CENTER	RIGHT	FRAME
SUPPORT	SUPPORT
FRAME	FRAME

AOpen HARDWARE BAG 1.

BAttach upper PULLEY assembly to CENTER SUPPORT FRAME using 2 bolts (D), 4 flat washers

(B)and 2 NYLON nuts (C). Tighten this hardware.

CPosition LAT BAR BRACKET ASSEMBLY in line with the

UPPER PULLEY ASSEMBLY and the LEFT SUPPORT FRAME and RIGHT SUPPORT FRAME as shown. Using 4 BOLTS (A), 8 FLAT WASHERS

(B)and 4 NYLON NUTS (C) attach SUPPORT PLATES, LAT BAR BRACKET ASSEMBLY and UPPER PULLEY ASSEMBLY to the LEFT SUPPORT FRAME and RIGHT SUPPORT FRAME as shown.

BACK COVER

FLAT WASHER (B)

NYLON NUT (C)

FRONT COVER

CENTER SUPPORT FRAME

FLAT WASHER (B)

BOLT (A) RADIAL ARM ASSEMBLY

SEAT WELDMENT SET

STEP 3-D: INSTALLING THE STOPPER:

RADIAL ARM ASSEMBLY

STOPPER

AOpen HARDWARE BAG 2.

BAttach SEAT WELDMENT SET.

CAttach Cover to bolted joint using 4 SCREWS (F).

DRemove STOPPER from front side of RADIAL ARM ASSEMBLY and reinstall on back side of

RADIAL ARM ASSMBLY.

EAttach RADIAL ARM ASSEMBLY to CENTER SUPPORT FRAME using 2 BOLTS (A), 4 FLAT WASHERS (B) and 2 NYLON NUTS (C).



ASSEMBLY

BEFORE YOU BEGIN

CONDITIONING GUIDELINES

TROUBLESHOOTING & MAINTENANCE

LIMITED WARRANTY

SXS_5.7_rev.1.1.indd 8-9 8/30/07 11:12:44 AM