Horizon Fitness T401 manual A S S E M B Ly Step, A Open HARDWARE BAG, A Open Hardware Bag

INTRODUCTION IMPORTANT

PRECAUTIONS

ASSEMBLY

BEFORE

YOU BEGIN

TREADMILL

OPERATION

CONDITIONING TROUBLESHOOTING LIMITED

GUIDELINES & MAINTENANCE WARRANTY



P R E - A S S E M B LY

DO NOT ATTEMPT TO LIFT THE TREADMILL!* Do not move or lift treadmill

WARNING from packaging until specified to do so in the assembly instructions. Failure to do so may result in injury! Remove plastic wrap from console masts.

Note: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before

completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware. Any grease, such as lithium bike grease is recommended.

A S S E M B LY STEP 1

HARDWARE BAG 1 CONTENTS :

BOLT (A)	FLAT WASHER (B)	TEFLON WASHER (C)
15 mm	20 mm	18 mm
Qty: 1	Qty: 1	Qty: 1
BOLT (D)	FLAT WASHER (E)	WAVY WASHER (F)
Qty: 1	27 mm	29 mm
	Qty: 1	Qty: 1

LEFT LINKAGE ARM	MAIN FRAME
LEFT CONSOLE MAST
WAVY WASHER (F)
FLAT WASHER (E)
BOLT (D)
TEFLON WASHER (C)
FLAT WASHER (B)
BOLT (A)	ELEVATION FRAME

AOpen HARDWARE BAG 1.

BCut banding straps. Do not move or lift treadmill from packaging.

CMove left linkage arm into position. Insert 1 bolt (A) and 1 FLAT WASHER (B) into left linkage arm followed by 1 Teflon washer (C) and attach to elevation frame.

DLift left console mast into upright position. Be sure to hold the console mast firmly, as it will not stay in the upright position on its own.

EInsert 1 bolt (D) and 1 FLAT washer (E) through left console mast followed by 1 WAVY washer (F) and attach to MAIN FRAME.

A S S E M B LY STEP 2

HARDWARE BAG 2 CONTENTS :

BOLT (D)	FLAT WASHER (E)	WAVY WASHER (F)	LOCK LATCH PIN (G)
Qty: 1	27 mm	29 mm	Qty: 1
	Qty: 1	Qty: 1

MAIN FRAME	LEAD WIRE
	RIGHT CONSOLE MAST
	RIGHT FOLDING FRAME
	LOCK LATCH PIN (G)
	CONSOLE CABLES

AOpen Hardware Bag 2.

BAttach LOCK LATCH PIN (G) into RIGHT FOLDING FRAME using T-wrench and tighten completely.

CPull LEAD WIRE through RIGHT CONSOLE MAST. After pulling the lead wire through the mast, the top of the console cable should be located at the top of the mast. Detach and discard lead wire.

DContinue step 2 on next page.



IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES

T401_Rev.2.3.indd 8-9 7/1/08 8:22:11 AM