Manuals / Hornet Car Security / Household Appliance / Home Security System

Hornet Car Security 700T manual status LED, optional starter kill relay

Models: 700T

1 28

Download 28 pages 63.89 Kb

Page 6

status LED

IMPORTANT! When the vehicle is delivered, please show the user where the switch is located and how to disarm the system with it.

status LED

Things to remember when positioning the Status LED:

■It should be visible from both sides and the rear of the vehicle, if possible.

■It needs at least 1/2-inch clearance to the rear.

■It is easiest to use a small removable panel, such as a switch blank or a dash bezel. Remove it before drilling your 9/32-inch hole.

■Use quick-disconnects near the LED wires if the panel is removable. This allows mechanics or other installers to remove the panel without cutting the wires.

optional starter kill relay

If the optional starter kill relay or its connections are immediately visible upon removal of the underdash panel, they can easily be bypassed. Always make the relay and its connections difficult to discern from the factory

6	© 2001 Directed Electronics, Inc. Vista, CA

Image 6

Hornet Car Security 700T manual status LED, optional starter kill relay

Contents

Installation Guide Model 700T2001 Directed Electronics, Inc. Vista, CA N700T Rev. E System Features Learn Routine table of contentsAuxiliary Harness H2 Wire Connection Guide Wiring Quick Reference Guidewhat is included installation points to remembertools required deciding on component locationsvalet/program switch control modulestatus LED optional starter kill relayfinding the wires you need finding the 12V switched ignition wireobtaining constant finding a + parking light wire finding the door pinswitch circuit finding the starter wiremaking your connections solderless butt connectionssolder connections H1/1 primary harness H1 wire connection guideIMPORTANT! Never interrupt any wire other than the starter wire H1/2H1/2 WHITE light flash output H1/3 WHITE/BLUE + trunk release/sensor shunt inputConnect this wire to the optional domelight supervision relay H1/7 VIOLET + door trigger input H1/8 BLACK - chassis ground connectionH1/9 YELLOW + ignition input the same point you connect the control module’s black ground wire H2/2 GREEN arm input auxiliary harness H2 wire connection guideH2/1 BROWN - horn honk output H2/3 RED disarm defeat inputLock Driver’s UnlockPassenger Unlock connecting door lock inputs in vehicles with driver’s door unlock and external relays door lock learn routine plug-in harnesses on-board stinger doubleguard shock sensorinternal programming jumper light flash jumpersystem features learn routine system features menu TWO CHIRPS - PRESS8 NO FUNCTION rapid resume logic troubleshootingtable of zones Shock sensor does not trigger the alarmThe Valet/program switch does not work Closing the door triggers the system, but opening the door does notStatus LED does not work wiring quick reference guide 2001 Directed Electronics, Inc. Vista, CA