Solder connections | Hornet Car Security 700T instruction

solder connections

3. Insert the twisted pair of wires into one end of the butt connector and crimp securely.

Vehicle Wire
Module Wire	Crimp	Vehicle Wire
		Vehicle Wire

4. Insert the other end of the vehicle’s wire into the other end of the butt connector and crimp securely.

Crimp

solder connections

1.Using your wire strippers and razor knife, strip about 1/2-inch of insulation off the wire to be connected to, without cutting the wire.

Stripped Vehicle Wire

2. Twist the security module’s wire around the bare section of the vehicle’s wire.

Vehicle Wire

Module Wire

3. Solder the bare connection thoroughly using rosin core solder.

Solder

Vehicle Wire

Soldering Iron

Module Wire

4. Completely insulate the connection with electrical tape.

© 2001 Directed Electronics, Inc. Vista, CA

11

Image 11

Hornet Car Security 700T manual solder connections

Contents

2001 Directed Electronics, Inc. Vista, CA N700T Rev. E Installation GuideModel 700T Wiring Quick Reference Guide table of contentsAuxiliary Harness H2 Wire Connection Guide System Features Learn Routine installation points to remember what is included deciding on component locations tools required control module valet/program switch optional starter kill relay status LED obtaining constant finding the wires you needfinding the 12V switched ignition wire finding a + parking light wire finding the starter wire finding the door pinswitch circuit solderless butt connections making your connections solder connections H1/2 primary harness H1 wire connection guideIMPORTANT! Never interrupt any wire other than the starter wire H1/1 H1/3 WHITE/BLUE + trunk release/sensor shunt input H1/2 WHITE light flash output Connect this wire to the optional domelight supervision relay H1/9 YELLOW + ignition input H1/7 VIOLET + door trigger inputH1/8 BLACK - chassis ground connection the same point you connect the control module’s black ground wire H2/3 RED disarm defeat input auxiliary harness H2 wire connection guideH2/1 BROWN - horn honk output H2/2 GREEN arm input Passenger Unlock LockDriver’s Unlock connecting door lock inputs in vehicles with driver’s door unlock and external relays door lock learn routine on-board stinger doubleguard shock sensor plug-in harnesses light flash jumper internal programming jumper system features learn routine TWO CHIRPS - PRESS system features menu 8 NO FUNCTION Shock sensor does not trigger the alarm troubleshootingtable of zones rapid resume logic Status LED does not work The Valet/program switch does not workClosing the door triggers the system, but opening the door does not wiring quick reference guide