Hornet Car Security 700T guide

Connect this wire to the optional domelight supervision relay.

H1/4 BLACK/WHITE 200 mA (-) domelight-supervision output

Connect this wire to the optional domelight supervision relay.

IMPORTANT! This output is only intended to drive a relay. It cannot be connected directly to the domelight circuit, as the output cannot support the current draw of one or more bulbs.

H1/5 GREEN (-) door trigger input

Most vehicles use negative door trigger circuits. Connect the green wire to a wire which shows ground when any

door is opened. In vehicles with factory delays on the domelight circuit, there is usually a wire that is unaffected

by the delay circuitry.

H1/6 BLUE (-) instant trigger

This input will respond to a negative input with an instant trigger. It is ideal for hood and trunk pins and will

report on zone one.

14	© 2001 Directed Electronics, Inc. Vista, CA

Image 14

Hornet Car Security 700T manual Connect this wire to the optional domelight supervision relay

Contents

2001 Directed Electronics, Inc. Vista, CA N700T Rev. E Installation GuideModel 700T System Features Learn Routine table of contentsAuxiliary Harness H2 Wire Connection Guide Wiring Quick Reference Guide what is included installation points to remember tools required deciding on component locations valet/program switch control module status LED optional starter kill relay obtaining constant finding the wires you needfinding the 12V switched ignition wire finding a + parking light wire finding the door pinswitch circuit finding the starter wire making your connections solderless butt connections solder connections H1/1 primary harness H1 wire connection guideIMPORTANT! Never interrupt any wire other than the starter wire H1/2 H1/2 WHITE light flash output H1/3 WHITE/BLUE + trunk release/sensor shunt input Connect this wire to the optional domelight supervision relay H1/9 YELLOW + ignition input H1/7 VIOLET + door trigger inputH1/8 BLACK - chassis ground connection the same point you connect the control module’s black ground wire H2/2 GREEN arm input auxiliary harness H2 wire connection guideH2/1 BROWN - horn honk output H2/3 RED disarm defeat input Passenger Unlock LockDriver’s Unlock connecting door lock inputs in vehicles with driver’s door unlock and external relays door lock learn routine plug-in harnesses on-board stinger doubleguard shock sensor internal programming jumper light flash jumper system features learn routine system features menu TWO CHIRPS - PRESS 8 NO FUNCTION rapid resume logic troubleshootingtable of zones Shock sensor does not trigger the alarm Status LED does not work The Valet/program switch does not workClosing the door triggers the system, but opening the door does not wiring quick reference guide