Cisco Systems OL-7822-06 quick start Connect the Local Console, page, C H A P T E R

C H A P T E R 4

Connect the Management Interfaces and Perform Initial System Configuration

This section explains how to connect the SCE 1000 platform to a local console and perform the initial system configuration via the setup wizard that runs automatically. Additionally, this section contains instructions for cabling the Fast Ethernet Management interface.

•Connect the Local Console, page 4-1

•Perform the Initial System Configuration, page 4-2

•Connect the Management Interface, page 4-25

Connect the Local Console

Figure 4-1 Connecting to the Local Console

MNG 1	MNG 2
		CONSOLE
LINK/ 10			AUX
ACTIVE 1	ALCINK/ 10/100/
	TIVE 1000

1 2 3

PWR A	PWR B	STATUS
			BYPASS

LINK RX		TX		LINK RX
						TX
RX	MM	TX
				RX	MM
						TX
	SUB		GBE-1
			LINE
					NET

Cisco SCE 1000 2xGBE

Series

92965

You must first connect the unit to a local console and configure the initial settings for the SCE 1000 to support remote management. When the initial connection is established, the setup utility will run automatically, prompting you to perform the initial system configuration.

Make sure that the terminal configuration is as follows:

•9600 baud

•8 data bits

•No Parity

•1 stop bits

•No flow control

Cisco Service Control Engine 1000 2xGBE Quick Start Guide

OL-7822-06 4-1