Cisco Systems OL-7822-06 quick start SCE 1000 Operational Status, Description, Status LED State

Chapter 8 Troubleshoot Startup Problems

SCE 1000 Operational Status

Table 8-1	SCE 1000 Operational States (continued)
SCE 1000 Operational Status		Description		Status LED State
Warning		SCE 1000 is fully operational (as		Flashing orange
		above) but one of the following
		occurred:
		• Line ports (GBE ports) to
			the link are down
		• Management port link is
			down
		•	Temperature raised above
			threshold
		• Voltage not in required
			range
		•	Fans problem
		•	Power supply problem
		• Insufficient space on the
			disk
		Note If the condition that
			caused the SCE 1000 to
			be in Warning state is
			resolved (for example,
			link is up) the SCE 1000
			reverts to Operational
			state.
Failure		System is in Failure state after		Red
		Boot due to one of the following
		conditions:
		• Power on test failure
		• Three abnormal reboots in
			less than 20 minutes
		• Platform configured to enter
			Failure mode consequent to
			failure-induced reboot (this
			is configurable using CLI
			command)
		Note Depending on the cause
			of failure, the
			management interface
			and the platform
			configuration may or
			may not be
			active/available.

Cisco Service Control Engine 1000 2xGBE Quick Start Guide

8-2 OL-7822-06