Cisco Systems OL-7822-06 Connect the GBE Line Interface Ports, Typical Max, SCE Model, Distance

Chapter 5 Cable the Line Ports

Cabling the Line Interfaces

Returns to Global Configuration Mode, from which you can enter the GigabitEthernet Interface configuration mode for the remaining GBE port.

Repeat this procedure to configure auto-negotiation for the other GBE port interface.

Connect the GBE Line Interface Ports

Refer to Information About Cabling, page 5-1to find the appropriate cabling diagram for the topology of your system.

Figure 5-3 Cabling the GBE Interface

MNG 1		MNG 2
LINK/	1010/10000/
ACTIVE		ALCINTIKV/E1010/10000/

CONSOLE

AUX

PWR A	PWR B	STATUS
			BYPASS

LINK
RX TX		LINK
				TX
			RX
		RX	MM	TX
SUB	GBE-1
	LINE
			NET

Cisco SCE 1000 2xGBE

Series

92962

The following table presents the fiber specifications. The SCE 1000 may be ordered with either Multimode or Single Mode transceivers The transceiver type is indicated on the front panel under the ports. Note that both transceivers on any individual SCE 1000 are the same, either 850nm Multimode OR 1310 Single Mode.

Table 5-1	Fiber Specifications
					Typical (Max.)
SCE Model		Transceiver	Transmit Power	Receive Power	Distance
SCE 1000 2xGBE		850nm Multimode	–9.5 to –4 dBm	–17 to 0 dBm	•	750m for
MM						50µm Core
						Diameter
						MMF
					•	400m for
						62.5µm Core
						Diameter
						MMF
SCE 1000 2xGBE		1310nm FRP laser	–9.5 to –3 dBm	–20 to 3 dBm	10 km for 9.0µm
SM		Single Mode			Core Diameter
					SMF

Step 1 Plug the specified fiber optic cable (see table above) into the appropriate GBE port on the front panel of the SCE 1000.

Step 2 Verify that the link LED is green.

Cisco Service Control Engine 1000 2xGBE Quick Start Guide

5-4 OL-7822-06