Cisco Systems OL-7822-06 quick start Installing the Crossrail Supports Four-post rack only

Chapter 2 Rack-Mount the SCE 1000

Installing the Crossrail Supports (Four-post rack only)

Figure 2-4 Attaching the Mounting Brackets (2-post)

MNG 1		MNG 2
LINK/	1010/10000/
ACTIVE		ALCINTIKV/E1010/10000/

CONSOLE

PWR A	PWR B	STATUS
			BYPASS

AUX

LINK		TX
	RX			LINK
						TX
					RX
RX	MM	TX
				RX	MM
						TX
	SUB		GBE-1
			LINE
					NET

Cisco SCE 1000 2xGBE

Series

210603

1 2

To install the rack-mount brackets on the SCE 1000 chassis, complete the following steps:

Before installing the SCE 1000 in the rack, you must first install a rack-mount bracket on each side of the front of the SCE 1000.

Step 1 Align the rack-mount bracket to the side of the SCE 1000. Choose the proper bracket for your installation (2-post rack or 4-post rack) as illustrated in Rack-Mount the SCE 1000

Step 2 Insert and tighten three screws.

Step 3 Repeat steps 1 and 2 on the other side of the SCE 1000.

If mounting the SCE 1000 in a rack with only two posts, skip to Mount the System to the Rack.

If mounting the SCE 1000 in a rack with four posts, proceed to the next step, Installing the Crossrail Supports (Four-post rack only).

Installing the Crossrail Supports (Four-post rack only)

This section provides information for assembling the crossrail supports and attaching them to the rack.

When mounting in a rack with four posts (front and back) the two crossrail supports are mounted one on each side of the rack. The SCE 1000 then slides into these crossrails, which support the weight of the unit.

•Assemble the Crossrail Supports

•Attach the Crossrail Supports to the Rack

Assemble the Crossrail Supports

Step 1 Assemble the two crossrail supports. Use three screws for each crossrail assembly.

Cisco Service Control Engine 1000 2xGBE Quick Start Guide

OL-7822-06 2-3