Cisco Systems OL-7822-06 quick start Connect the Management Interface, Example, 4-25

Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration

Connect the Management Interface

Data collection for the system configuration is completed.

Would you like to view the new configuration before it is applied? [yes/no]:

Apply and Save this configuration? [yes/no]: n

The changes you have just entered would be discarded, are you sure? [yes/no]:y

Setup procedure aborted, no configuration changes made.

Connect the Management Interface

Figure 4-2 Cabling the Management Port

PWR A PWR B STATUS

MNG 1				MNG 2
						CONSOLE
LINK/							AUX
ACTIV	00	/	LINK/		10/100/
			AC
				TIVE 1000

1 2 3

LINK RX		TX	LINK RX
					TX
RX	MM	TX
			RX	MM
					TX
	SUB	GBE-1
		LINE
			NET

		Cisco
			SCE
				2000
LINK RX			4xGBE
		TX	LINK RX
					TX
RX	MM	TX
			RX	MM
					TX
	SUB	GBE-2
	LINE/CASCADE NET

Series

92791

Note By default, the management port is configured to auto-negotiation enabled.

The SCE 1000 has two management ports, labeled Mng1 and Mng 2. Use the Mng 1 port.

Step 1 Plug the Ethernet cable provided (with attached RJ-45 connector) into the Mng 1 port on the front panel of the SCE 1000.

Step 2 Connect the other end of the Ethernet cable into your management network.

The Link LED on the SCE 1000 management port should light up.

Step 3 Test connectivity. From the host that you intend to use for remote management, ping to the SCE 1000 by typing ping and the SCE 1000 IP address, and pressing Enter (see the example, below).

This verifies that an active connection exists between the specified station and the management port.

EXAMPLE:

The following example displays a typical ping response where the target IP address is 10.1.1.201.

C:\>ping 10.1.1.201 pinging 10.1.1.201 ...

PING 10.1.1.201: 56 data bytes

64bytes from host (10.1.1.201): icmp_seq=0. time=0. ms

64bytes from host (10.1.1.201): icmp_seq=1. time=0. ms

64bytes from host (10.1.1.201): icmp_seq=2. time=0. ms

64bytes from host (10.1.1.201): icmp_seq=3. time=0. ms

----10.1.1.201 PING Statistics----

4packets transmitted, 4 packets received, 0% packet loss round-trip (ms) min/avg/max = 0/0/0

Cisco Service Control Engine 1000 2xGBE Quick Start Guide

OL-7822-06 4-25