Cisco Systems OL-7822-06 quick start Definition, Setup Command Parameters continued

Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration

Perform the Initial System Configuration

Table 4-1	Setup Command Parameters (continued)
Parameter		Definition
Access Control List number		How many ACLs will be necessary? What IP
		addresses will be permitted/denied access for each
		management interface? You may want ACLs for
		the following:
		•	Any IP access
		•	Telnet access
		•	SNMP GET access
		•	SNMP SET access
list entries (maximum 20 per list)		IP address, and whether permitted or denied
		access.
IP access ACL		ID number of the ACL controlling IP access.
telnet ACL		ID number of the ACL controlling telnet access.
SNMP agent status		Enable or disable SNMP management.
GET community names		Community strings to allow GET access and
		associated ACLs (maximum 20).
SET community names		Community strings to allow SET access and
		associated ACLs (maximum 20).
trap managers (maximum 20)		Trap manager IP address, community string, and
		SNMP version.
Authentication Failure trap status		Sets the status of the Authentication Failure traps.
enterprise traps status		Sets the status of the enterprise traps.
system administrator		Name of the system administrator.
Topology Configuration
connection mode		Is the SCE 1000 installed using inline topology or
		receive-only topology using an optical splitter?
link bypass mode on operational status		When the SCE 1000 is operational, should it
		bypass traffic or not?
link bypass mode on non-operational status		When the SCE 1000 is not operational, should it
		bypass traffic or cut it off?
priority		If this is a cascaded topology, is this SCE 1000 the
(cascade topology only)		primary or secondary SCE 1000?
operational status of the SCE after abnormal boot		After a reboot due to a failure, should the SCE
		1000 remain in a Failure status or move to
		operational status provided no other problem was
		detected?

Following are some general instructions regarding the setup dialog:

•All default values appear in square brackets [default] .

If no value appears in the brackets [], or more than one option appears [ yes/no ], then this parameter does not have a default value.

Cisco Service Control Engine 1000 2xGBE Quick Start Guide

OL-7822-06 4-5