Cisco Systems OL-7822-06 quick start Summary Steps, Detailed Steps, Enter time zone name UTC CET

Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration

Perform the Initial System Configuration

You must enter the time setting menu to configure SNTP settings. You may choose to skip the time settings menu if you wish to accept all default values.

Note Unlike all other settings defined in the system configuration, setting the time is done immediately and not at the end of the setup process.

SUMMARY STEPS

1.Enter the time settings menu.

2.Configure the time zone name.

3.Specify the offset from UTC.

4.Confirm the local time and date.

5.Enter the SNTP configuration menu.

6.Configure the SNTP broadcast client. By default the SNTP broadcast client is not enabled.

7.Define the time interval between unicast updates.

8.Specify an IP address for the SNTP unicast server.

DETAILED STEPS

Step 1 Enter the time settings menu.

Would you like to enter the Time settings menu? [no]: y

Type y and press press Enter.

Step 2 Configure the time zone name.

Type the time zone abbreviation and press press Enter.

Enter time zone name [UTC]: CET

Step 3 Specify the offset from UTC.

Type the minutes offset from UTC and press press Enter.

Enter time zone minutes offset from UTC: 60

Step 4 Confirm the local time and date.

The local time and date are displayed, and you are asked whether you want to change them

The local time and date is 15:00:01 CET FRI 01 July 2002

Would you like to set a new time and date? [no]:

•If the time and date are correct, press

•Enter

•and go to Step 5.

•If the time and date are not correct, answer yes to the above question, and press press Enter.

Would you	like to set		a new time and date? [no]: y
Confirm your response			and type the new time and date.
This change will		take	effect immediately both on the system clock and calendar;
it will also set		the	time zone you entered. Are you	sure? [yes/no]: y
Enter new	local time		and date: 14:00:01 1 July 2002
Time zone	was successfully set.
The system clock		and	the calendar were successfully	set.

Step 5 Enter the SNTP configuration menu.

Cisco Service Control Engine 1000 2xGBE Quick Start Guide

OL-7822-06 4-9