Cisco Systems OL-7822-06 quick start 4-17, Detailed Steps, Enable SNMP management? no y

Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration

Perform the Initial System Configuration

7.To add more entries, do not accept the default::

8.Enter up to 20 SNMP GET communities as described in step 3.

9.When all entries have been added, accept the default:

10.Configure the SNMP SET community.

11.Type the SNMP SET community name and press press Enter.

12.Assign an access list to restrict the SNMP management stations that may use this SET community.

13.Configure additional SET communities.

14.To add more entries, do not accept the default::

15.Enter up to 20 SNMP SET communities as described in step 5.

16.When all entries have been added, accept the default:

17.Configure the SNMP trap managers.

18.Enter the SNMP trap managers menu.

19.Configure the trap manager IP address

20.Configure the trap manager community string

21.Configure the trap manager SNMP version.

22.Configure additional trap managers.

23.To add more entries do not accept the default:

24.Enter up to 20 trap managers as described in step 7.

25.When all entries have been added, accept the default:

26.Configure the Authentication Failure trap status.

27.Configure the SCE enterprise trap status.

28.Specify the system administrator.

DETAILED STEPS

Step 1 Enter the SNMP configuration menu.

Would you like to enter the SNMP configuration menu? [no]: y

Type y and press press Enter.

The SNMP configuration dialog begins.

Step 2 Enable SNMP management.

Type y and press press Enter.

Enable SNMP management? [no]: y

If you choose to disable SNMP management, skip the rest of this section and go to . The rest of the dialog is not presented, as it is irrelevant when SNMP management is disabled.

Step 3 Configure the SNMP GET community.

a.Type the SNMP GET community name and press press Enter.

The SNMP agent that resides inside the SCE 1000 will respond only to GET requests that use this community string.

Enter SNMP GET community name:

Note that there is no default for this parameter.

Cisco Service Control Engine 1000 2xGBE Quick Start Guide

OL-7822-06 4-17