2 Before You Begin

2.1 Installation Summary

The basic steps to install the CBR-PB3-WD unit are:

1.Connect the PB3 to the Receipt Printer using the supplied cable. (If more than two PB3 units are used, verify that proper termination is set on each individual PB3 unit.

2.Connect the PB3 to the DVMRe-CT/eZT/StoreSafe unit using the supplied cable (RJ45-to-RJ45). (If your unit is a DVMRe-CD/CS, the required interconnect cable is also provided (RJ45-to-DB9 - see Section 11 for the specific requirements for the DVMRe-CD/CS).

3.On each PB3, set the Camera ID switches for each PB3 that is to be associated with a specific camera.

4.Program the DVMRe unit to record in the way desired to meet your specific sites.

2.2How to Use this Manual

We recommend that at least the following pages be reviewed before attempting an installation.

qProBridge 3 Diagram on page 9.

qConnection Diagram on page 11.

qInstallation & Configuration on pages 13-15.

2.3Kalatel Components:

(1)CBR-PB3-WD ProBridge includes:

(1) CBR-PB3-WD ProBridge unit.

(1) P/N 4310-0034B: RJ45 to RJ45 cable. Connects the ProBridge to RS-485 Network. This cable is 6’ in length.

(1) P/N 4310-0047B: RJ45 to DB9F cable. Connects the ProBridge to the DVMRe. This cable is 6’ in length.

(1) P/N 4310-0078A: DB9F to DB9M to DB9F ‘Y’ cable. Connects the ProBridge to the Electronic Cash Register (ECR) and the Receipt Printer This cable is 6’ in length.

(1) P/N 4010-0007: 12VDC 120VAC Power Supply or

(1) P/N 4010-0008: 12VDC 220VAC Power Supply.

(1) P/N 0150-0261A: Product Overview and Installation Manual.

Kalatel CBR-PB3-WD

6

0150-0261A

Page 6
Image 6
GE CBR-PB3-WD installation manual Before You Begin, Installation Summary, How to Use this Manual, Kalatel Components