GE CBR-PB3-WD installation manual HyperTerminal Setup, Equipment Required

Models: CBR-PB3-WD

1 37
Download 37 pages 30.12 Kb
Page 26
Image 26
10 HyperTerminal Setup

10 HyperTerminal Setup

Manual configuration can also be completed using Windows HyperTerminal in lieu of the dipswitches. Manual configuration should only be used if the “POS Device Selection” does not conform to your specific device because baud rates or protocols are slightly different than the default values for the selected device.

10.1 Equipment Required

q(1) Windows 98/NT/2000/XP Desktop or Laptop PC.

q(1) DB9F to RJ45 cable (included with your unit).

Configuration using Windows HyperTerminal uses the supplied RJ45-to-DB9 cable provided with your unit. Disconnect the PB3 unit from the DVMRe and hook-up the cable as follows:

The RJ45 end connects to the outside receptacle of Port 1 of the PB3 unit and the DB9 end connects to your PC’s COM Port (typically COM1).

10.1 Equipment Required IMPORTANT: If you program the ProBridge via NOTE HyperTerminal you must BACKUP (Save) the

program information via the BACKUP option so that everytime the unit is powered up, the settings you configured will be used.

Kalatel CBR-PB3-WD

26

0150-0261A

Page 26
Image 26
GE CBR-PB3-WD installation manual HyperTerminal Setup, Equipment Required