Instructions for the fitter
GB
Mounting the wooden panel onto the door and inserting the machine into cabinets:
In the case where the machine must be shipped for final installation after the wooden panel has been mounted, we suggest leaving it in its original packaging. The packaging was designed to make it possible to mount the wooden panel onto the machine without removing it completely (see figures below). The wooden panel that covers the face of the machine must not be less than 18 mm in thickness and can be hinged on either the right or left. For the sake of practicality when using the machine, we recommend that the panel be hinged on the same side as the door for the machine itself - the left.
Door Mounting Accessories (Fig.
N° 2 Hinge Supports |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
| N° 2 Hinges | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Fig. 1 | Fig. 2 | |||||||
| N° 1 Magnet |
| N° 1 Magnet plate |
|
|
|
|
Fig. 3 | Fig. 4 | ||
AB
CD
E
| N° 1 Rubber plug |
| N° 1 Spacer |
|
|
|
|
|
|
|
|
Fig. 5 | Fig. 4/B | ||
-No. 6 type A
-No. 2 type B metric, countersunk screws, l =25; for fastening the magnet plate to the cabinet.
-No. 4 type C metric screws, l =15 mm; for mounting the hinge supports to the cabinet.
-No. 4 type D metric screws, l =7 mm; for mounting the hinges on the supports.
Mounting the Parts onto the Face of the Machine.
-Mount the hinge supports onto the face of the machine, positioning the hole indicated by the arrow in fig. 1 towards the inside of the face and using the type C screws.
-Mount the magnetic plate on the opposite side, at the top, using the two type B screws.
-Place the spacer illustrated in fig. 4/B between the appliance front and the magnet receiver.
$
