Care and Cleaning
‘STAY CLEAN’ Oven liners
Refer to the instructions below for cleaning the ‘Stay clean’ panels.
How “STAY CLEAN” works:
The surfaces of the ‘Stay clean’ oven liners are treated on the mottled face with a special vitreous enamel which absorbs cooking soils. At temperatures of 220˚C (425˚F) or above, the special surface enables these soils to be slowly destroyed. The higher the temperature the more effective it is. In most cases normal cooking operations at this temperature will permit this cleaning operation to proceed during cooking. However if higher cooking temperatures are not used regularly it may be necessary in order to prevent heavy soiling, to run the oven without a meat pan at maximum setting for a couple of hours.
Main Oven Liners | - | side and rear panels. |
Top Oven Liners | - | sides |
It should not normally be necessary to clean the ‘Stay clean’ panels in water. If the user feels it is desirable to do so, wash them in warm soapy water, followed by rinsing in clean water. Do not use enzyme/biological washing powder, harsh abrasives or oven chemical cleaners of any kind.
Decorative trims (all models):
It is advisable to clean the decorative trims regularly to prevent any build up of soiling which may detract from the appearance of the cooker. The recommended method of cleaning is to wipe over the trims with a soft cloth wrung out in hot water or mild
Never use scouring pads or abrasive cleaners/powders which may scratch the surface.
Take care during cleaning not to damage or distort the door seals. Do not lift the door seal from the oven chassis, if necessary remove the seal by carefully unhooking the corner clips.
Take care that the rating label edges are not lifted during cleaning, and furthermore that the lettering is not blurred or removed.
Control Panel:
Wipe with a damp cloth and polish with a dry cloth.
Stainless trims:
Regularly wipe with a clean, damp cloth and polish with a clean dry cloth.
Grill Door:
Wipe over the grill door decorative outer panel; with a cloth wrung out in warm soapy water, then after wiping with a cloth wrung out in clear water, dry with a soft clean cloth.
Do not use scouring pads or abrasive powder which may scratch the surface. Ensure that the glass panel is not subjected to any sharp mechanical blows.
32
