GB Introduction

!Before placing your new appliance into operation please read these operating instructions carefully. It contains important information concerning the safe installation and operation of the appliance.

!Please keep these operating instructions for future reference. Make sure that the instructions are kept with the appliance if it is sold, given away or moved.

!The appliance must be installed by a qualified professional in accordance with the instructions provided.

!Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply.

The cookers have the following technical specifications:

Category: II 2H3+

This appliance must be installed in accordance with the regulations in force and only used in a well ventilated space. The data badge is fitted on the rear panel. The model/serial number can also be found on a badge located below the left-hand oven door beneath the door seal.

Read these instructions before installing or using the appliance and retain them for future reference.

These instructions are only valid for the countries whose symbols appear in the manual and on the serial number plate.

To help you make the best use of your cooker, PLEASE READ THIS BOOKLET CAREFULLY.

Your new cooker is guaranteed and will give lasting service. The guarantee is only applicable if the cooker has been installed in accordance with the Installation Instructions. The cooker is designed specifically for domestic use and responsibility will not be accepted for use in any other installation.

When first using the cooker ensure that the room is well ventilated (e.g. open a window or use an extractor fan) and that persons who may be sensitive to the odour avoid any fumes. It is suggested that any pets be removed from the room until the smell has ceased. This odour is due to any temporary finish and also any moisture absorbed by the insulation.

Our policy is one of continual improvement in design and development, therefore strict accuracy of illustrations and descriptions cannot be guaranteed.

Installation

Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the data badge which is fitted on the back panel.

This appliance is not designed to be connected to a combustion products evacuation device. It must be installed and connected in accordance with current installation regulations. particular attention should be given to the relevant requirements regarding ventilation.

MODEL NUMBERS

CH10450GF S, CH10455GF S, CH10456GF S Category II2H3+ (GB. IE)

This model is set to burn NATURAL GAS (G20) at 20 mbar but can be converted for use on BUTANE (G30) at 28-30mbar or PROPANE (G31) at 37mbar with the use of a service kit supplied with the appliance or available from our Service and Genuine Parts and Accessories department (see back cover).

GAS SAFETY (INSTALLATION & USE) REGULATIONS It is the law that all gas appliances are installed by competent persons in accordance with the current edition of the above regulations. It is in your interest and that of safety to ensure compliance with the law.

In the UK, CORGI registered installers work to safe standards of practice.

The cooker must also be installed in accordance with Current national legislation.

Failure to install the cooker correctly could invalidate the warranty liability claims and could lead to prosecution.

LOCATION

The cooker may be located in a kitchen, kitchen/diner or a bed-sitting room, but not in a room containing a bath or shower. The cooker must not be installed in a bed-sitting room of less than 20m3.

When adjusted for use on BUTANE (G30) or PROPANE (G31) the cooker must not be installed in a room or internal space below ground level, eg. in a basement.

PROVISION FOR VENTILATION

The room containing the cooker should have an air supply in accordance with Current national legislation.

The room must have an opening window or equivalent; some rooms may also require a permanent vent. If the room has a volume between 5 and 10m3, it will require an air vent of 50cm2 effective area unless it has a door which opens directly to outside. If the room has a volume of less than 5m3, it will require an air vent of 100cm2 effective area. If there are other fuel burning appliances in the same room, in accordance with Current national legislation should be consulted to determine air vent requirements.

DIMENSIONS

Height: 900 - 915 mm

Widht: 1000 mm

Depth: 600 mm (excluding door handles)

GENERAL

 

Gas connection

Rp ½ (½” BSP female)

Pressure test point

Hotplate burner injector

Gas rate adjustment

None

Aeration adjustment

None

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

4

Page 3 Page 5
Page 4
Image 4
Hotpoint CG 40456 GF S, CH 10450 GF S, CG 10455 GF S manual GB Introduction, Installation
Page 3 Page 5

CG 10455 GF S, CG 40456 GF S, CH 10450 GF S specifications

The Hotpoint CH 10450 GF S, CG 40456 GF S, and CG 10455 GF S are three high-performance cooking appliances that exemplify contemporary kitchen design and functionality. Each model brings a unique set of features and technologies aimed at enhancing the cooking experience while ensuring reliability and efficiency.

One of the primary features of the Hotpoint CH 10450 GF S is its gas cooking capability, which provides rapid heat and precise temperature control. This model includes a powerful burner system with multiple burner types, allowing cooks to select the ideal flame size for different dishes, from simmering sauces to searing meats. The easy-to-clean stainless steel surface not only enhances the look of your kitchen but also ensures a straightforward maintenance process.

The CG 40456 GF S stands out with its even cooking features, incorporating a multi-zone burner setup that distributes heat evenly across the cooking surface. This model features a large oven capacity, making it suitable for families or those who enjoy entertaining guests. With its advanced thermostat technology, it ensures that your meals cook evenly, reducing hot spots and preventing overcooking.

On the other hand, the CG 10455 GF S focuses on versatility and convenience. It integrates a range of cooking modes, which include fan-assisted cooking and traditional roasting options. This model is designed for users who seek efficiency, as it minimizes cooking times while maintaining food quality. Additionally, it comes with programmable settings, heightening user experience by allowing them to pre-set cooking times and temperatures, ideal for busy households.

All three models are equipped with safety features, such as flame supervision devices that automatically cut off the gas supply if the flame goes out. Moreover, their energy efficiency ratings contribute to a reduced environmental footprint and lower energy costs.

In summary, the Hotpoint CH 10450 GF S, CG 40456 GF S, and CG 10455 GF S are designed to meet the demands of modern kitchens. They combine innovative technologies, user-friendly features, and a commitment to safety and efficiency, making them ideal choices for both aspiring and seasoned home chefs. Their elegant designs and robust performance capabilities ensure they not only function well but also complement a contemporary kitchen aesthetic.
Top Page Image Contents