Washing Dishes
Programme selection
The most appropriate programme can be identified by comparing the type of crockery, cutlery etc., as well as the amount and condition of food remains, with the details contained in the programme overview.
The corresponding programme sequence, duration and consumption details are shown in the bottom half of the overview.
For example:
Use the “Normal” programme for dishes and utensils which have plenty of food remains stuck on hard.
Reduce costs
If only a small number of dishes have been loaded into the dishwasher, selecting a programme that operates at the next lowest temperature will usually suffice.
Programme data
The stated programme data are based on standard operating conditions. The values can vary considerably according to:
-Different amounts of dishes
-Temperature of mains water supply.
-Pressure of mains water supply
-Ambient temperature
-Fluctuations in mains voltage.
-
Energy and water consumption is reduced by up to 1/4 when dishes are washed in the upper basket only.
Water consumption values are based on a water hardness setting of:
4 for Models DWF35 and DWF34
2 for Models DWF33 and DWF30
End of Programme.
-(Models DWF35 and DWF34 only) The programme has ended when a figure 0 appears in the numerical display 7 .
-(Models DWF33 and DWF30 only) The programme has come to an end when the Programme End indicator
10 light and the selected programme indicator are both illuminated.
Switching the dishwasher OFF
Several minutes after the programme has ended:
-Set the mains switch to OFF.
-Turn the water tap off.
-Remove dishes, etc. when they have cooled down.
Interrupting the programme.
-Set the mains switch to OFF.
-The indicator light will go out. The programme is retained in the dishwashers memory.
-If the hot water was switched ON or the appliance has already heated up and then the appliance door opened, leave the door ajar for several minutes and then close.
Otherwise, the appliance door may fly open due to expansion.
-In order to resume the stored programme, set the mains switch to ON again.
Note:
Switching the dishwasher ON.
-Press the mains switch to ON. The indicator lights light up according to the last selected programme. The same programme will run again if no other programme button is pressed.
-(Models DWF35 and DWF34 only) The numerical display 7 shows the expected duration of the programme. The programme starts automatically.
-(Models DWF33 and DWF30 only)
The programme starts automatically.
19
