Hotpoint H050E manual Installation, Warning - This Appliance Must Be Earthed

Installation

WARNING – THIS APPLIANCE MUST BE EARTHED.

Your cooker should be checked to ensure that the voltage corresponds with your supply voltage, this is stated on the rating plate, which is situated on the rear panel as shown on page 5. The cooker must be connected by a competent person such as one registered with the National Inspection Council for Electrical Installation Contracting (NICEIC) to a suitable double-pole control unit with a minimum rating of 45A and a minimum contact clearance of 3mm, which should be fitted adjacent to the cooker, in accordance with IEE regulations.

The power supply cable should conform to B.S.6004 with a conductor size of 6mm2 minimum.

The control unit should be easily accessible in the event of an emergency.

This appliance conforms to EN55014 regarding suppression of radio and television interference.

Access to the mains terminals is gained by removing the rear access cover.

The mains cable must pass through the cable clamp on rear panel and ensure that the rear access cover is replaced after fitting the cable. Sufficient cable should be used to allow the cooker to be pulled out for servicing.

18