Remote control panel

Note:

If wireless remote controller is lost, open the surface panel and operate manually.

1

2

3

4

POWER BUTTON

Operation starts when pressing this button, and stops when pressing this button again.

SWING BUTTON

Activate the automatic air swing function.

FAN SPEED BUTTON

Select the fan speed HIGH, MID, LOW and AUTO in sequence.

TEMP/TIMER BUTTON

Press the keypad to increase the set (operating) temperature of the unit.and Press the keypad to decrease the set (operating) temperature of the unit. The temperature seting range is from 16~30℃

Press the keypad also to increase the selected time in 1 hour increments,and Press the keypad to decrease the selected time in 1 hour decrements,The time seting range is from 0~24 hours.

5SIGNAL RECEIVER

6MODE BUTTON

Select the operation mode, AUTO, HEAT, COOL, FAN, DRY (for reverse cycle model) or AUTO,COOL,FAN, DRY (for cooling only model).

7FILTER BUTTON

This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation and cooling. The LED (light) will illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Check Filter" button and the light will go off. Before the LED(light) illuminate, press the "Check filter" button until after 3 seconds, the accumulated time of. Operation will be canceled.

VENTILATION LEVER

When the slider at the:

When the slider at the:

 

 

 

 

 

 

 

 

 

 

CLOSE VENT OPEN

CLOSE VENT OPEN

 

-"OPEN" position,the ventilation door

-"CLOSE" position,the ventilation door

 

opens to allow air,smoke or odors to

is closed and the air will be circulated

 

be expelled from the room.

inside the room and conditioned.

Ventilation Lever

 

 

13