Installation procedure:

1)Remove the sticker from the front panel.

2)Put the unit into the installation hole.

When installing the unit, it should be slanted down to the back to avoid the enlargement of noise or vibration. (Slant between 6-10mm.) (Shown at right figure.)

The installation place should be strong enough to avoid the enlargement of noise or vibration.

3)Fill up sews in the cabinet with sponge or foam.

Installation assistance:

Use iron support

The installation hole should be strong enough to support the air conditioner. If it cannot, iron support has to be used outdoors.

Iron support should be fixed on the building (Shown at right figure.)

Use sunshade board

Air conditioner should avoid anything to be dropped into it and avoid direct sunshine. If there is no cover on it, you should contact the seller for installing the sunshade board. When installing the sunshade board, don’t let it block the air inlet at the side grille.

Horizontal line

Wall

Sunshade board

Wooden frame

Rubber plate

Support

Horizontal line

Drain water:

To get the maximum cooling efficiency, the air conditioner is designed to splash the condensation water on the condenser coil.

To the cooling only unit,If the splashing sound annoys you, you can provide an outside drain by using the follo -wing procedure, whichmay however cause a small loss of performance.

1.Slide out the chassis from the cabinet.

2.Remove the rubber plug from the body base plate.

3.Install the drain pan to the corner of the cabinet with 2 screws.

4.Connect the drain hose to the outlet on the drain pan bottom.

5.Slide the chassis into its original place in the cabinet.

4