Care and Cleaning
Ensure the glass panel is not subjected to any sharp mechanical blows. Take particular care not to damage the inner surface which is coated with a heat reflective layer. After cleaning, rinse and dry with a soft cloth. For slight soiling the inner glass panel may be cleaned, while still warm, without removing it from the door.
Warning: Oven must not be operated with inner door glass removed.
To reassemblethe oven doors proceed with inserting the glass pannels in the reverse order, pushing gently every panel directly into the liners.
BE CAREFUL NOT TO
DAMAGE THE GLASS
PANELS BY PUSHING
THEM TOO HARD.
When refitting the glass make sure it is fitted correctly i.e. reflective face is fitted the right way round.
!Never use steam cleaners or pressure cleaners on the appliance.
!Clean the glass part of the oven door using a sponge and a
!The accessories can be washed like everyday crockery (even in your dishwasher).
!Switch off the electricity supply and allow to cool before cleaning the cooker.
!Clean the cooker regularly and wipe up spills soon after they occur to prevent them from becoming burnt on. Never use biological washing powder, caustic cleaners, harsh
abrasives, scouring pads, steam cleaners,
aerosol cleaners or oven chemical cleaners of GB any kind.
!If it is necessary to remove the cooker for cleaning, ensure that it is cool and beware that it is heavy (approximately 70 kg 155 lbs).
!To move the cooker forward, open the top oven/ grill door and with both hands positioned under the roof of the compartment, lift and pull forward. Replace by pushing the cooker backwards.
!Check that the cooker is level. Take care not to damage any floor coverings.
OVEN HEAT CLEAN LININGS
The oven side linings are coated with a special enamel which has a continuous cleaning action.
The higher the oven temperature the more effective the action. In most cases this cleaning operation will proceed during normal cooking. However, if roasting is done frequently, or high temperatures are not used regularly, it may be necessary to occasionally operate the oven empty at Mark 8 for about an hour.
It should not normally be necessary to clean the linings with water, but if desired, wipe them over with a soapy cloth, followed by a wipe with a damp clean cloth.
REPLACEMENT OF OVEN LIGHT
BULB
CAUTION: DISCONNECT THE APPLIANCE FROM THE ELECTRICITY SUPPLY BEFORE REPLACING THE LAMP TO AVOID THE POSSIBILITY OF AN ELECTRIC SHOCK.
Light bulbs are not covered by the manufacturer's guarantee.
A new 25W, 300°C rated SES bulb can be obtained from your cooker supplier or any major electrical retailer.
1.Remove the shelves from the oven.
2.Unscrew the lens using a thick cloth to protect your fingers in the unlikely event of a lens fracture.
3.Unscrew bulb.
4.Fit new bulb and refit lens.
!Do not use the oven lamp as/ for ambient lighting.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
19
