Installation
WARNING - THIS APPLIANCE MUST BE EARTHED.
Mains Connection
Your cooker should have been checked to ensure that the voltage corresponds with your supply voltage, this is stated on the rating plate, which is situated on the outer rear panel.
The model number and serial number are located on the front of the cooker, as shown on the Feature's page.
The cooker must be connected by a competent person such as one who is a, NICEIC registered contractor to a suitable
The double pole control unit should be fitted adjacent to the cooker, in accordance with IEE regulations. The control unit must be within 2 metres of but not directly above the appliance and should be easily accessible in the event of an emergency. The power supply cable should conform to B.S.6004 with a conductor size of 6mm2, minimum.
Access to the mains terminals is gained by removing the rear access cover. The mains cable must pass through the cable clamp adjacent to the terminal block. Sufficient cable should be used to allow the cooker to be pulled out for servicing.
Ensure that the mains cable is routed away from any brackets affixed to the rear panel and is not trapped to the rear wall when pushing the cooker into position between cabinets.
Levelling
Four feet are fitted which can be adjusted up or down to set the height (900mm - 930mm) and level the cooker.
The feet can be simply screwed in or out to lower or raise the cooker.
After the correct height is achieved, lock the feet into position by tightening the locking nut using an open ended spanner.
CAUTION: Some soft floor coverings may get damaged if the cooker is not moved carefully. NOTE: Ensure oven shelves are level by using a spirit level on the rod shelves.
Siting the Cooker |
| |||
GB | ||||
The cooker is designed to fit between kitchen | ||||
cabinets spaced 600mm apart. The space either |
| |||
| ||||
side need only be sufficient to allow withdrawal of |
| |||
the cooker for servicing and cleaning. |
| |||
It can be used with cabinets one side or both as well |
| |||
as in an angled corner setting. It can also be used |
| |||
freestanding. |
| |||
Adjacent side walls which project above hob level, |
| |||
must not be nearer to the cooker than 150mm and |
| |||
should be protected by heat resistant material. Any |
| |||
overhanging surface or cooker hood should not be |
| |||
nearer than 650mm. |
| |||
Note: This appliance must NOT be fitted on a |
| |||
platform. |
| |||
Moving the Cooker |
| |||
Before moving your cooker, switch off at the cooker |
| |||
control unit, ensure that it is cool. |
| |||
Open the grill door sufficiently to allow a comfortable |
| |||
grip on the underside front edge of the oven roof, |
| |||
avoiding any grill elements. |
| |||
Radio Interference |
| |||
This appliance conforms to EN 55014 regarding |
| |||
suppression of radio and television interference. |
| |||
Note: Take care in moving the cooker as it is |
| |||
heavy. Take care to ensure that any floor |
| |||
covering is not damaged. |
| |||
|
|
|
| |
The cooker is fitted with a safety |
|
|
| |
chain that must be attached to a |
|
|
| |
hook, secured to the wall behind the |
|
|
| |
appliance. |
|
|
| |
|
|
|
| |
This appliance conforms with the following European Economic Community directives:
-2006/95/EC of 12/12/06 (Low Voltage) and subsequent modifications;
-2004/108/EC of 15/12/04 (Electromagnetic Compatibility) and subsequent modifications;
-2009/142/EC of 30/11/09 (Gas) and subsequent modifications (only for models which use gas);
-93/68/EEC of 22/07/93 and subsequent modifications.
-2002/96/EC
-1275/2008
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
5
