CARE AND CLEANING
LIGHT REPLACEMENT
The hood can be provided with different types of lamps: incandescent, halogen and neon lamps.
•Incandescent lamps (Fig.6): lamps with E14 cap, 40W power and 230V voltage, generally olive shaped.
To replace them, remove the grease filters, unscrew the faulty lamp and screw in the new one, replace the grease filters. If using an electronic bulb, use only those with an E14 coupling, max. 11W.
•Halogen lamps (Figs.7 & 8): Fig.7 illustrates the type of lamps with E14 cap, 50W power and 230V voltage. To replace them, follow instructions given above for incandescent lamps. Fig.8 illustrates the type of lamps with G4 cap, 20W power and 12V voltage.
To replace them, use a screwdriver to remove the glass support ring A (Fig.9), then remove the protection glass B. Pull out the used bulb and replace it with the new one. Replace the protection glass B fastening it in place with support ring A. If using a 12V dichroic halogen (Fig.8a) lamp, use only those with a GU5.3 coupling max. 20W.
•Neon lamps (Fig.10): neon lamps can come with a ‘mignon’ G5 cap (8W or 13W power and 288mm or 516mm long) or a normal G13 cap, (15W or 23W power and 437mm or 970mm long). To replace them, remove the metal grease filters, detach the neon, rotating it 90 degrees and pull it out of its housing. Fit the new neon light then replace the metal grease filters.
•Starter Replacement: for all types of neon lamps, use a
CLEANING
•Clean with a sponge soaked in warm water and a sodium bicarbonate solution, which is among other things a good disinfectant. If you do not have any, you can use a neutral soap.
•Clean steel parts by rubbing in the direction of the surface finish.
•DO NOT use abrasive detergents, bleach or detergents using ammonia.
•NEVER use solvent based products.
Failure to carry out the basic standards of cleaning and replacement of the filters could cause a fire risk. Therefore you must observe these instructions.
GB |
| 11 |
