Hotpoint HX901X Installation, Assembly Instructions, 1ST TYPE OF SUPPORT, 2ND TYPE OF SUPPORT

INSTALLATION

Assembly Instructions

The accessories required for the installation of the hood can be found inside the packaging. The hood is convertible and can therefore be installed for use in either the OUTDOOR VENTING mode or the AIR RECIRCULATION mode. If the hood is used in the OUTDOOR VENTING mode, connect opening ‘N’ (Fig.1) to an exhaust duct connected directly to the outside and which is 150cm2 minimum in cross-section. The lowest part of the hood should be at least 70cm from the hob.

•IN NO CASE WHATSOEVER SHOULD THE HOOD BE CONNECTED TO EXHAUST DUCTS FROM OTHER APPLIANCES THAT RUN ON ENERGY SOURCES OTHER THAN ELECTRICITY (water heaters, boilers, stoves etc.). The hood must not be placed above stoves with a top radiant hob.

•There are 3 main types of supports for anchoring a hood onto a wall. As a rule each hood has tow main anchoring points, one at either side on the back of the hood.

1ST TYPE OF SUPPORT

•This support is assembled onto the hood and allows for the adjustment of the hood both vertically (screw L, Fig.2) and horizontally (screw F, Fig.2). For the installation, L-shaped hooks must be fastened to the wall (see E, Fig.2).

2ND TYPE OF SUPPORT

This support is already assembled on the cooker hood and only allows vertical adjustment, by turning the screw situated on the high part of the hood (see Side b). L-shaped hooks must be fastened to the wall for installation.

GB 4