Hotpoint OSX 1036U D CX Electrical connection, The plug and socket must be easily accessible

Electrical connection

!Ovens with a three-pole power supply cable are designed to operate with alternated current at the supply frequency and voltage indicated on the data plate (at the bottom of the oven dashboard). The earthing conductor of the cable is the yellow-green conductor.

Two types of connection are provided: Connection n° 1

Connecting the power supply cable to the mains. Fit a normalized plug to the cable, which corresponds to the load indicated on the data plate; if the cooker is connected directly to the mains, an omnipolar circuit-breaker with a minimum opening of 3 mm between the contacts, suitable for the load indicated and complying with current directives, must be installed between the appliance and the mains (the earthing wire must not be interrupted by the circuit-breaker). The power supply cable must be positioned so that it does not exceed room temperature by 50°C at any point of its length. Before making the connection check that:

• the circuit breakers or fuses of the home system can support appliance load (see data plate);

• the power supply system has an efficient earthing connection which complies with the provisions of current regulations and the law;

• there is easy access to the socket or the omnipolar circuit-breaker once the cooker has been installed.

!do not use reducers, adapters or shunts as these could cause heating or burning.

Connection n° 2

electrical supply to your machine, consult a qualified

electrician before use.				GB
How to connect an alternative plug
The wires in this mains
lead are coloured in		GREEN &
accordance with the		YELLOW
following code:		BROWN	13 amp fuse
BLUE“NEUTRAL” (N)
BROWN	“LIVE” (L)	BLUE	CROSS-BAR
GREEN AND YELLOW			CORD GRIP
“EARTH”	(E)

Disposing of the appliance

When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above.

!The plug and socket must be easily accessible.

APPLIANCE SPECIFICATIONS

width 43.5 cm

Dimension* height 41 cm depth 41 cm

Volume* 74 l

width 45.6 cm

Dimension** height 41 cm depth 41 cm

Volume** 77 l

Disposing of the plug.

!THIS APPLIANCE MUST BE EARTHED.

Electrical

voltage: 230 - 240 V~ 50/60Hz maximum power absorbed

Ensure that before disposing of the plug itself, you make the pins unusable so that it cannot be accidentally inserted into a socket. Instructions for connecting cable to an alternative plug:

!the wires in the mains lead are coloured in accordance with the following code:

Green & Yellow	-Earth
Blue	-Neutral
Brown	-Live

If the colours of the wires in the mains lead do not correspond with the coloured markings identifying the terminals in your plug, proceed as follows.

Connect Green & Yellow wire to terminal marked “E” or 6 or coloured Green or Green & Yellow.

Connect Brown wire to terminal marked “L” or coloured Red. Connect Blue wire to terminal marked “N” or coloured Black. If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse.

A 15 amp plug must be protected by a 15 amp fuse, either in the plug or adaptor or at the distribution board.If you are in any doubt about the

connections

2600-2800 W (see data plate)

Directive 2002/40/EC on the label of electric ovens.

Standard EN 50304

ENERGY

LABELDeclared energy consumption for Forced convection Class – heating mode: ECO

This appliance conforms to the following European Economic Community directives:

2006/95/EEC dated 12/12/06 (Low Voltage) and subsequent amendments

– 2004/108/EEC dated 15/12/04 and subsequent amendments

- 93/68/EEC dated 22/07/93 and subsequent amendments

-2002/96/EC and subsequent amendments.

1275/2008 Standby/off mode

*Only for models with drawn rails.

**Only for models with wire rails.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

3