Hotpoint X156G manual Care and Cleaning

Care and Cleaning

	Clean the cooker regularly and wipe up spills soon after they
	occur to prevent them from becoming burnt on. Never use biological
	washing powder, caustic cleaners, harsh abrasives, scouring pads,
	aerosol cleaners or oven chemical cleaners of any kind.
	To move the cooker forward, open the grill door and with both
	hands positioned under the roof of the compartment, lift and pull
	forward. Replace by pushing the cooker backwards. Check that the
	cooker is level. Take care to ensure that any floor covering is not
	damaged.
	Do not attempt to lift the product using the grill door or grill door
	handle.
Stay clean Oven	The oven side linings are coated with a special enamel which has a
Linings	continuous cleaning action. The higher the oven temperature the
	more effective the action. In most cases this cleaning operation
	will proceed during normal cooking. However, if roasting is done
	frequently, or high temperatures are not used regularly, it may be
	necessary to run the oven empty at Mark 8 for about two hours.
	If desirable, they can be washed with warm soapy water followed by
	a rinse.
Oven Door /	Wipe over the door outer panel with a cloth wrung out in warm
Grill Door	soapy water, then after wiping with a cloth wrung out in clear
	water, dry with a soft clean cloth.
	Take care during cleaning not to damage or distort the Door Seal.
	Do not lift the Door Seal from the Oven Front Frame, if necessary
	remove the seal by carefully unhooking the corner clips.
	Do not use scouring pads or abrasive powder which may scratch
	the surface.
Model X156G only:	The battery is not covered by the guarantee. Use an alkaline AA
Replacing	battery. The battery holder is located in the plinth panel below the
the Battery	oven door. Open the oven door fully. Press the tag on the left hand
	side of the battery holder/cover and withdraw it just enough to get
	access to the battery. Fit the new battery with the end marked “+”
	on the same side of the battery holder as the red lead.
	Replace the battery holder by pushing it firmly into the hole in the
	plinth.
Model 5TCG only:	CAUTION: DISCONNECT THE APPLIANCE FROM THE ELECTRICITY
Replacement of	SUPPLY BEFORE REPLACING THE LAMP TO AVOID THE POSSIBILITY
oven light bulb	OF AN ELECTRIC SHOCK.
	Light bulbs are not covered by the manufacturers guarantee.
	A new 15W, 300˚C rated SES bulb can be obtained from you cooker
	supplier or any major electrical retailer.
	1. Remove the shelves from the oven.
	2. Unscrew the lens using a thick cloth to protect your fingers in
	the unlikely event of a lens fracture.
	3. Unscrew bulb.
	4. Fit new bulb and refit lens.

14