Installation Procedure

6. Verify Operation

6. Verify Operation

Verify proper operation of the HP-PB 100VG-AnyLAN Network Adapter by checking the LEDs on the card. When the computer is switched on, the Power LED will come on. At this point, the rest of the LEDs are in an uninitialized state, and cannot be used until the driver on the system has been started. After the driver has been started, the following Table 1-1,may be used to interpret the LED patterns.

Table 1-1

LED Patterns

 

 

 

 

 

 

LED

LED on

LED off

 

 

 

 

 

Test

Driver has detected a

Adapter is functioning

 

 

fatal condition and is no

correctly.

 

 

longer operating.

 

 

 

 

 

 

10

Adapter is operating at

Adapter is not operating at

 

 

10Mbps.

10Mbps.

 

 

 

 

 

100

Adapter is operating at

Adapter is not operating at

 

 

100Mbps.

100Mbps.

 

 

 

 

 

Link

Adapter is correctly

Adapter is not receiving a

 

 

receiving a link signal

link signal from the

 

 

from the hub/switch.

hub/switch.

 

 

 

 

 

Activity

Adapter is sending or

No packet is currently being

 

 

receiving a packet to/from

transferred to/from the

 

 

the hub/switch.

hub/switch.

 

 

 

 

 

Power

Adapter is receiving

The system is not supplying

 

 

power from the system.

power, or the adapter is not

 

 

 

seated properly in the slot.

 

 

 

 

22

Chapter 1