09 Maintenance
Purpose / To read and, if necessary, adjust the preventive maintenance counter, which counts the number of swaths.
This Calibration must be used to reset the Maintenance counter to ZERO after the Preventive Maintenance Kit has been installed in order to disable the •Maintenance Advised" message on the front.panel.
Note down the Swaths Counter (####) before replacing the Electronics Module.
Adjust the Swaths Counter (####) after replacing the Electronics Module.
Use the following keys to adjust the swaths counter.
DUp Arrow / Increase the Counter Digit.
DDown Arrow / Decrease the Counter Digit.
DEnter / Select the Next digit.
10 Font Type Set (On'y avai'ab'e in HP DesignJet 2500P printer)
Purpose / To check and, if necessary, select a Font type (only possible when the printer detects that a new Hard Disk has been installed).
YOU MUST PERFORM THIS ALIRATION WHEN YOU INSTALL A NEW ELETRONIS MODULE IN ORDER TO SET THE ORRET FONT TYPE
If you have not installed a new Electronics Module, current font type will be displayed.
If you have installed a new Electronics Module, •Character Set New" will be displayed. Press Up Arrow key to set new type font.
The message •Choose Character Set" will be displayed on the front/panel. Use Up and Down Arrow keys to select font type required and then press Enter.
The first time a PostScript print is sent to the printer, the other font types wi'' be deleted and cannot be recovered.
IF YOU DO NOT SELECT ANY FONT SET, THE ROMAN FONT WILL BE
SELECTED BY DEFAULT WHEN A POSTSCRIPT FILE IS SENT.
HP DesignJet 2500CP and 2000CP Printers | Quick Reference Service Manual 15 |
