Windows NT Workstation Requirements | HP 3C590-TPO instruction

3Connecting to a Windows NT Server 3.51 Windows NT Workstation 4.0

Windows NT

•HP Vectra with Windows NT Workstation 4.0 Service Pack 3.

•3COM Etherlink 3C509-B ethernet card and drivers disk ver 5.0. Driver Name: Elnk3.SYS Size: 27KB Date: 7/18/96

•Microsoft Windows NT Workstation 4.0 and service pack media.

(If you have a Hewlett-Packard pre-loaded HDD, the media is located at “C:\I386”)

•Microsoft Windows NT Server 3.51 machine that supports Net BEUI, TCP/ IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

•	I/O Base Address	300
•	Interrupt Request Level	10
•	Boot PROM	Disabled
•	Transceiver Type	Auto Select
•	Network Driver Optimization	Windows or OS/2 Client
•	Maximum Modem Speed	9600 Baud
• Plug and Play Compatibility		Disabled
•	Full Duplex	Disabled

1With the HP Vectra turned off, install the 3COM Etherlink III 3C509-B adapter card into an ISA slot.

2Connect network media to the 3COM 3C509B card.

3Insert a DOS bootable diskette and power on the machine.

4After booting, insert the 3COM Etherlink 3C509-B Ethernet card and drivers disk ver 5.0. and execute “A:\3C5X9CFG.EXE.”

5Select “CONFIGURE NIC”, and verify the resource settings listed above under the heading “Device Configuration.”

6If changes are required, save those changes and exit.

7Remove the 3com cards driver diskette and reboot the machine.