Table
Allows you to set and enable a | ||
| after a power cycle. If the user does not enter the correct | |
| boot. |
|
| NOTE: This selection will only appear when at least one drive that supports the DriveLock | |
| feature is attached to the system. | |
| See the Desktop Management Guide for more information. | |
|
| |
Password Options | Allows you to enable/disable: | |
(This selection appears | ● | Lock Legacy Resources (appears if a setup password is set). Default is enabled. |
only if a | ● | Setup Browse Mode (appears if a setup password is set) (allows viewing, but not changing, |
password or setup | ||
password is set.) |
| the F10 Setup Options without entering setup password). Default is enabled. |
| ● Password prompt on F9, F11, & F12 (allows access to menus without entering setup | |
|
| password). Default is enabled. |
| ● Network Server Mode (appears if a | |
| See the Desktop Management Guide for more information. | |
|
| |
Smart Cover (some | Allows you to: | |
models) | ● Lock/unlock the Cover Lock. | |
| ||
| ● Set the Cover Removal Sensor to Disable/Notify User/Setup Password. | |
| NOTE: Notify User alerts the user that the sensor has detected that the cover has been | |
| removed. Setup Password requires that the setup password be entered to boot the computer if | |
| the sensor detects that the cover has been removed. | |
| This feature is supported on some models only. See the Desktop Management Guide for more | |
| information. | |
|
| |
Device Security | Allows you to set Device Available/Device Hidden (default is Device Available) for: | |
| ● Embedded security device (some models) | |
| ● | System audio |
| ● Serial ports (some models) | |
| ● Parallel port (some models) | |
| ● | Network controller |
|
| NOTE: You must disable AMT before trying to hide the network controller. |
| ● | SATA0 |
| ● | SATA1 |
| ● | SATA2 (some models) |
| ● | SATA3 (some models) |
| ● | SATA4 (some models) |
|
|
|
10 Chapter 2 Computer Setup (F10) Utility