Reverse this procedure to reassemble and install the Bluetooth module.
RTC batteryDescription | Spare part number |
|
|
RTC battery | |
|
|
Before removing the RTC battery, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.
4.Remove the battery (see Battery on page 44).
Remove the RTC battery:
1.Position the computer
2.Loosen the two Phillips PM2.0×5.0 captive screws (1) that secure the memory module compartment cover to the computer.
3.Lift the right side of the cover (2), swing it up and to the left, and remove the cover. The memory module compartment cover is included in the Plastics Kit, spare part number
4.Disconnect the RTC battery cable (1) from the system board.
54 Chapter 4 Removal and replacement procedures