Addendum to D Class Enterprise Servers System Installation Guide

Installation

8.Using item 16 screws (only) attach the bezel mount brackets (items 5, 6 in Figure 1-3) to the vertical rails as shown. Attach the two clip-on receptacles (item 30) at the bottom of the brackets as shown.

9.For full GR-63-CORE NEBS compliance, attach only the two bezel clips at the top of the brackets using item 29 screws. (Optionally attach two clips at the bottom as well.)

10.Attach the bezel support (item 8) to lower area of vertical rails using item 16 screws (only) as shown. Top edge of bezel support is flush with bottom of bezel mount brackets.

11.Position top cover (item 1) in upper area as shown. Install but don’t tighten screws.

Figure 1-3 Seismic Rack Installation

16

Chapter 1